Home > Maintenance

How to wrap your drop handlebars like a pro

A simple fix with a great effect

Wrapping handle

Nothing throws off the look of a road bike like worn out, dirty bar tape. You can freshen up your ride by replacing the tape regularly to keep it from getting too worn or torn. Fresh tape just makes the bike look and feel great again. I have probably wrapped thousands of handlebars throughout the years. As with any skill, practice makes perfect. A simple task it may be, but for that pro look, follow these steps.

Out with the old

Remove the old tape and clean up any residue on the handlebar. Sometimes bits of the old tape may be left behind. You don’t want to wrap over the gunk as it might create bumps and bulges.

Capitalize on the clear view

When you have the bar tape removed, it’s a good time to inspect the cable housing and ferrules where they enter the shifters. Make any needed replacements. This is also a good time to re-position the shifters on the bar if you need to as it is much harder to make these adjustments when the bars are wrapped.

Plan your route

Using electrical tape, secure the cable housing to the handle bar evenly. Next, decide where you want the handlebar wrap to end. If you have an aero bar with flat tops, the tape will likely stop soon after the shifter. With a more traditional bar, bring the wrap closer toward the stem. Use electrical tape to mark the end points and add some extra security to the housing. I like to use a pair of scissors to gauge an equal distance from each side of the stem.

Clamp down

Take the two extra pieces for covering the shifter-lever clamps. Cut them to the exact length of the clamp beforehand so they’re ready to go. You can also extend each one a tiny bit past the clamp on certain lever types to cover ferrule junctions. Don’t extend it so much that you cover brake hood lugs. Take your first roll of tape. If it has a paper backing, remove it completely to make the tape easier to work with.

Get wrapping

Start your wrap at the bar end. Always wrap from the inside outward. On the right side, you’ll wrap clockwise; on the left, counter-clockwise. When you put the tape on this way, the wrapping job will resist the stresses from the rider’s hands in the drops, which tend to pull the tape in the opposite direction. Position the end of the tape so it extends about halfway over the edge of the bar. Keep the tape taut while wrapping a couple turns. At this point, install your bar plug and give it a light tap with a mallet if needed. Putting in the plug early allows you to go back to even things out at the bar end if necessary.

Start wrapping while keeping tension on the tape, but don’t overstretch it. Some handlebar-tape material might need a bit more tension than others to avoid wrinkling. Ensure the wrap is even as you move along toward the lever.

A hard turn

The most difficult part for some is navigating the hoods. There are many different methods, but the best is the figure eight. When you get the tape half a length away from the lever body, position the piece you pre-cut for covering the clamp, and then wrap up and across it, coming over the top of lever body and crossing back over and down again. You cross down and back under the lever body. This time instead of crossing over, come up past the lever and onto the bar again, keeping even tension the whole time. Continue wrapping, keeping the gaps even up until the point at which you want the tape to end.

Finishing the job

You want the handlebar tape to end where you marked it previously with electrical tape. Extend your wrap just behind this mark and grab some sharp scissors. Trim the excess leaving about 1–2” extra. Then cut the tape at an angle to match the angle of wrap. The tape should now line up with your end point. You may need to stretch or trim to make it perfect. Use electrical tape to hold the end down. Then begin to stretch the electrical tape and wrap around the end point just over the edge of the handlebar wrap to seal it. Go around a few times to make it even. Cut your electrical tape to end underneath the handlebar for a clean look.

Finally, stand back and marvel at the excellent job you did.